top of page

Week four at Abbott's Mill, replacing the sill beam along the front of the mill

Oct 28
1 min read
Compare this with the photo below, from last week. The crew only has three or four feet to work in, between the  mill and the guard rails.
Compare this with the photo below, from last week. The crew only has three or four feet to work in, between the mill and the guard rails.
Part of the old sill beam that is being replaced.
Part of the old sill beam that is being replaced.
Judging by the growth rings, this Red Oak tree was at least 60 years old when it was sawn into this beam. If White Oak had been used, it might have lasted longer.
Judging by the growth rings, this Red Oak tree was at least 60 years old when it was sawn into this beam. If White Oak had been used, it might have lasted longer.
Some of the same beam, farther down.
Some of the same beam, farther down.
The inside view of the same area where the old beam was removed.
The inside view of the same area where the old beam was removed.
A pegged mortise and tenon at the end of the beam. where the corner post fit in.
A pegged mortise and tenon at the end of the beam. where the corner post fit in.

 
 
 
Post: Blog2_Post
  • Facebook
  • Twitter
  • LinkedIn

©2020 by Abbotts Mill Grist. Proudly created with Wix.com

bottom of page